CSA8000+ TDS8000+ CSA8000B+ TDS8000B+ CSA8200+ TDS8200+ DSA8200+ 80SICON+ 80SSPAR+ 80SICMX: What are some good measurement practices for best measurement results?

Question:

CSA8000+ TDS8000+ CSA8000B+ TDS8000B+ CSA8200+ TDS8200+ DSA8200+ 80SICON+ 80SSPAR+ 80SICMX: What are some good measurement practices for best measurement results?

Answer:

The following are some suggestions to optimize measurement results:

  • Let the instrument warm up for at least
  • 20-30 minutes before performing the measurements
  • Perform the required calibrations
  • Use good quality low loss cables and probes
  • Use a lot of averaging to reduce noise
  • Use a maximum number of acquisition points
  • De-skew the channels in the TDR -oscilloscope, as specified by your oscilloscope manual.

This FAQ Applies to:

Product: CSA8000B, CSA8000, TDS8000, TDS8000B, CSA8200, TDS8200, 80SICON, 80SSPAR, 80SICMX

FAQ ID : 55351

View all FAQs »
Téléchargements
Télécharger

Télécharger des manuels, des fiches techniques, des logiciels, etc. :

Go to top